Ask Randall: Mounting Outdoor Lanterns

Residential Lighting has another great Ask Randall Section. See below the correct way to mount an outdoor lantern.

Mounting Outdoor Lanters

The right height for placing outdoor lights depends on the positioning of the light source in the fixture, says our expert.

Question: I am wiring a new room and want to include outdoor wall sconce lights by French doors. I haven't picked out the lights yet, so I want to leave options open as much as possible. What sort of junction boxes should I install: round or single-gang rectangular, metal or plastic? How high? The exterior is lapped siding with a 6-inch reveal. Answer: First off, I want to congratulate you on having the forethought to add exterior sconces flanking the French doors. This will help keep them from becoming black mirrors at night and add a little architectural jewelry to the facade. As far as a junction box goes I would use a round 3-inch box. This can be a noncorrosive metal box or plastic. It would be really good if you could pick a fixture ahead of time before installing the boxes because that will help greatly in determining what the correct mounting height should be. A good rule of thumb is that the center of the light source should be 6 feet above the patio or deck (whatever the French doors are leading out onto). Some exterior fixtures do not have the electrical feeds exactly in the center of the backplate; sometimes they are closer to the top. Also, some fixtures hang down from an arm, or are raised up on an arm. These configurations affect the correct mounting height. For example, you’ll see the ELK Lighting Freeport fixture (left) has the electrical feed toward the top of the backplate. It’s not centered on the backplate. In contrast, the Quoizel Oasis lantern (center) hangs lower than the junction box. So in this case, the junction box has to be mounted higher than 6 feet so that the light source ends up at the 6-foot height. The Sea Gull Wynfield lantern illustrates a light source situated above the backplate. For these styles, the junction box would need to be installed lower in order for the light source to situate at 6 feet. My advice: Just bite the bullet and find the fixtures that you’re going to use. You need to buy the horse before you hitch up the cart. It will also help knowing the size of the backplate so that you can cut the right size opening in the siding.

			Randall Whitehead, IALD, is a professional lighting designer and author. His books include "Residential Lighting, A Practical Guide." Whitehead has worked on projects worldwide, appeared on the Discovery Channel, HGTV and CNN, and he is a regular guest on Martha Stewart Living Radio. Visit his website (www.randallwhitehead.com) and follow his blog (www.lightmakesright.com) for more information on books, upcoming seminars and the latest lighting trends.

Make It Glow- Issue 15

Check out our latest issue of Make It Glow!!!

Landscape 101

Paul Gosselin, President of the Association of Outdoor Lighting Professionals and President fo landscape lighting specialist NightScenes Corp. offers the dos and donts of outdoor lighting.

DO control glare. Make sure that you can't see the source of the light from primary viewing angles. You want to see the effect of the light, not the source.

DO think about different lighting sources. You don't want to use the same fixture and lamp for everything. Some areas will need wider or softer light while others will need an intense focus of light.

DO leave a few feet of extra wire. Do this for each fixture location to allow for later adjustment as the landscape matures.

DON'T use too much light. Less is more. Use lower-lumen fixtures instead of throwing a lot of light at objects.

DON'T forget to adjust your lighting at night. You may need to move things around a few times to get the best effects.

DON'T bury your wires as you go along. You want to be absolutely sure where your fixtures will end up first.

Source: Residential Lighting